Filter
Top Products
Port Traffic Controls
Rate-Limiting
ProCurve# show rate-limit all a1-a6
All-Traffic Rate Limit Maximum %
| Inbound Radius | Outbound Radius
Port | Limit Mode Override | Limit Mode Override
----- + --------- --------- ----------- + --------- --------- -----------
A1 | Disabled Disabled No-override | 200 kbps No-override
A2 | Disabled Disabled No-override | 200 kbps No-override
A3 | Disabled Disabled No-override | 200 kbps No-override
A4 | Disabled Disabled No-override | 200 kbps No-override
A5 | 20 % No-override | Disabled Disabled No-override
A6 | Disabled Disabled No-override | Disabled Disabled No-override
Ports A1-A4 are configured with an
outbound rate limit of 200 Kbps; Port A5 is
configured with an inbound rate limit of 20%.
(Port A6 is not configured for rate-limiting.)
Figure 13-1. Example of Listing the Rate-Limit Configuration
Note To view RADIUS-assigned rate-limit information, use one of the following
command options:
show port-access
web-based clients < port-list > detailed
mac-based clients < port-list > detailed
authenticator clients < port-list > detailed
For more on RADIUS-assigned rate-limits, refer to the chapter titled “Config-
uring RADIUS Server Support for Switch Services” in the latest Management
and Configuration Guide for your switch.
The show running command displays the currently applied setting for any
interfaces in the switch configured for all traffic rate-limiting and ICMP rate
limiting. The show config command displays this information for the configu-
ration currently stored in the startup-config file. (Note that configuration
changes performed with the CLI, but not followed by a write mem command
do not appear in the startup-config file.)
13-7