Filter
Top Products
Redundancy (Switches 8200zl)
Using Redundant Management
ProCurve(config)# redundancy switchover
This management module will now reboot from primary image and will become
the standby module! You will need to use the other management module's
console interface. Do you want to continue [y/n]? y
ROM information:
Build directory: /sw/rom/build/bmrom(t2g)
Build date: Mar 15 2007
Build time: 08:24:27
Build version: K.12.02
Build number: 13040
Select profile (primary):
Booting Primary Software Image...
.
.
.
Standby Console#
Figure 15-4. An Example of the Redundancy Switchover Command
Setting the Active Management Module for Next Boot
You can select which management module you want to be the active
management module at the next “boot system” or switchover event. Enter this
command:
Syntax: redundancy active-management <standby | management-module1 |
management-module2>
The specified module becomes the active management
module at the next system boot. This message displays: “On
the next system boot, the <module specified> will become
active.”
This command will not take effect if the standby
management module has failed selftest.
management-module1: Configures management-module 1 as
the active management module for the next system boot.
management-module2: Configures management-module 2 as
the active management module for the next system boot.
standby: Configures the current standby module as the active
management module for the next system boot if redundancy
is enabled. If redundancy is disabled, it will become enabled
as a standby module at the next boot or failover event.
15-9