Filter
Top Products
---- ---------------------------------------- -------- ----------- ---------
---- ---------------------------------------- -------- ---------- ----------
Redundancy (Switches 8200zl)
Using Redundant Management
ProCurve(config)# show redundancy
Settings
------- -
Mgmt Redundancy : Disabled
Redundancy disabled
Statistics
--------- -
Failovers : 0
Last Failover :
Slot Module Description Status SW Version Boot Image
1 ProCurve J9092A Management Module 8200zl Active K.12.XX Primary
2 ProCurve J9092A Management Module 8200zl Offline K.12.XX Primary
1 ProCurve J9093A Fabric Module 8200zl Enabled
2 ProCurve J9093A Fabric Module 8200zl Enabled
ProCurve Switch 8200zl(config)# redundancy active-management standby
On the next system boot, the standby will become active.
Redundancy and Synchronization have been disabled, so it will
not have current configurations.
ProCurve Switch 8200zl(config)# boot
The other management module is not in standby mode and this command will
not cause a switchover. System will reboot from primary image.
Do you want to continue [y/n]? y
(After system reboots...)
ProCurve Switch 8200zl(config)# show redundancy
Settings
Redundancy disabled
--------
Mgmt Redundancy : Disabled
Statistics
--------- -
Failovers : 0
Last Failover :
Slot Module Description Status SW Version Boot Image
1 ProCurve J9092A Management Module 8200zl Standby K.12.XX Primary
2 ProCurve J9092A Management Module 8200zl Active K.12.XX Primary
Figure 15-6. Example Showing Results of Switching to Standby Module when Redundancy is Disabled
15-11