Port Status and Configuration
Using Friendly (Optional) Port Names
Syntax: [no] module <slot>
Allows removal of the module configuration in the configura-
tion file after the module has been removed. Enter an integer
between 1 and 12 for <slot>.
For example:
ProCurve(config)# no module 3
Note This does not change how hot-swap works.
Operating Notes
The following restrictions apply:
■ The slot being cleared must be empty
■ There was no module present in the slot since the last boot
■ If there was a module present after the switch was booted, the switch will
have to be rebooted before any module (new or same) can be used in the
slot.
■ This does not clear the configuration of a module still in use by the switch.
10-32