Filter
Top Products
--
Redundancy (Switches 8200zl)
Displaying Management Information
ProCurve(config)# show version
Management Module 1:
Redundancy and Synchronization has been disabled:
enable with the ‘redundancy’ command.
Management Module 2: Active
Image stamp: /sw/code/build/btm(t2g)
Mar 5 2007 13:20:59
K.12.XX
351
Boot Image: Primary
Figure 15-17. Example of show version Command when Redundancy is Disabled
Show Log
The show log command displays the status of the switch and its management
modules. See “Logging Messages” on page 15-41. To show log messages in
reverse chronological order (most recent messages displayed first), enter
show log -r.
ProCurve Switch 8200zl(config)# show log
Keys: W=Warning I=Information
M=Major D=Debug
---- Event Log listing: Events Since Boot ----
M 01/26/14 17:34:07 sys: 'System reboot due to Power Failure'
I 01/26/14 17:34:07 00061 system: --------------------------------------------
I 01/26/14 17:34:07 00062 system: Mgmt Module 2 went down without saving crash
information
I 01/26/14 17:36:14 00264 system: Mgmt Module 1 Failed Selftest
I 01/26/14 17:36:19 00068 chassis: Fabric 1 Inserted
I 01/26/14 17:36:19 00068 chassis: Fabric 2 Inserted
I 01/26/14 17:36:19 00068 chassis: Slot D Inserted
I 01/26/14 17:36:19 00690 udpf: DHCP relay agent feature enabled
I 01/26/14 17:36:19 00400 stack: Stack Protocol disabled
I 01/26/14 17:36:19 00128 tftp: Enable succeeded
I 01/26/14 17:36:19 00417 cdp: CDP enabled
I 01/26/14 17:36:19 00688 lldp: LLDP - enabled
I 01/26/14 17:36:19 00066 system: Mgmt Module 2 Booted
I 01/26/14 17:36:19 00260 system: Mgmt Module 2 Active
I 01/26/14 17:36:19 00066 system: Mgmt Module 1 Booted
I 01/26/14 17:36:19 00261 system: Mgmt Module 1 in Standby Mode
Figure 15-18. An Example of the Show Log Command Output
15-26