Filter
Top Products
Colored paper
●
Colored paper should be of the same high quality as white xerographic paper.
●
Pigments used must be able to withstand the fuser temperature of 200°C (392°F) for 0.1 second
without deterioration.
●
Do not use paper with a colored coating that was added after the paper was produced.
Custom-size media
Use the main input tray for multiple sheets. See Supported media weights and sizes for the
supported media sizes.
CAUTION Make sure that the sheets are not stuck together before you load them.
Labels
HP recommends that you print labels from the priority input tray. See Loading media for more
information.
CAUTION Do not feed a sheet of labels through the device more than once. The adhesive
degrades and might damage the device.
Label construction
When selecting labels, consider the quality of the following components:
●
Adhesives: The adhesive material should be stable at 200°C (392°F), the maximum fuser
temperature.
●
Arrangement: Only use labels with no exposed backing between them. Labels can peel off
sheets that have spaces between the labels, causing serious jams.
●
Curl: Before printing, labels must lie flat with no more than 13 mm (0.5 inch) of curl in any
direction.
●
Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
Transparencies
Transparencies must be able to withstand 200°C (392°F), the maximum fuser temperature.
CAUTION You can print transparencies from the 150-sheet tray (tray 1). However, do not
load more than 75 transparencies at one time into the tray.
ENWW Guidelines for using media 17