Filter
Top Products
Installing the System
Console Setup
Chapter 3
126
MP MAIN MENU:
CO: Console
VFP: Virtual Front Panel
CM: Command Menu
CL: Console Logs
SL: Show Event Logs
HE: Main Menu Help
X: Exit Connection
This example shows the MP Main Menu accessed through the local serial port. The list of commands displayed
on the screen can be different depending on the method of access to the iLO MP.
When logging in using the local or remote RS-232 serial ports, the login prompt may not display if another
user is logged in through these ports. Use
Ctrl-B to access the MP Main Menu and the iLO MP prompt (MP>).
Additional Setup
This section provides additional information to help you set up the iLO MP.
Modifying User Accounts and Default Password
The iLO MP comes preconfigured with default factory settings, including a default user account and
password. The two default user accounts at initial login are:
• All Rights (Administrator) level user:
login = Admin
password = Admin
• Console Rights (Operator) level user:
login = Oper
password = Oper
NOTE User account and password are case sensitive.
IMPORTANT For security reasons, HP strongly recommends that you modify the default settings during the
initial login session.
Make the following changes using any of the iLO MP user interfaces.
To modify default account configuration settings, follow these steps:
Step 1. Log in as the administrator. You must log in as the administrator in order to modify default user
configuration settings.
Step 2. To modify default passwords, follow these steps:
a. Access the
MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify default passwords.
Step 3. To set up user accounts, follow these steps:
a. Access the
MP Main Menu.
b. Enter CM at the MP> prompt.