Filter
Top Products
Chapter 6
Removing and Replacing Components
Power Distribution Board
262
Figure 6-53 Power Distribution Board Removal and Replacement
Replacing the Power Distribution Board
To replace the power distribution board, follow these steps:
Step 1. Replace the power distribution board over the keyway slots and push it towards the side of the
chassis to lock it onto the studs.
Step 2. Reattach the power distribution board to the chassis bulkhead by replacing the one T-15 screw and
hand tightening it.
Step 3. Replug the power and signal cables into the midplane riser board.
Step 4. Replace the hot-swappable power supplies into the chassis. (See “Replacing a Hot-Swappable Power
Supply” on page 260.)
Step 5. Replace the power supply fan unit into the chassis. (See “Replacing a Hot-Swappable Chassis Fan
Unit” on page 206.)
Step 6. Replace the top cover. (See “Replacing the Top Cover” on page 183.)
Power Distribution Board
Attaching
Screw Hole