Filter
Top Products
Chapter 6
Removing and Replacing Components
Memory Extender Board
184
Memory Extender Board
The memory extender board is located directly under the front cover of the chassis. The standard memory
extender board can hold up to 16 DIMMs. The optional high capacity memory extender board can hold up to
32 DIMMs.
WARNING Ensure that the system is powered off and all power sources have been disconnected
from the server before removing or replacing a memory extender board.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions can result in damage to the server.
Removing a Memory Extender Board
To remove a memory extender board, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See “Accessing a Rack-Mounted
Server” on page 177.)
NOTE The memory extender board can be removed without removing the server from the
rack.
Step 2. Remove the front bezel. (See “Removing the Front Bezel” on page 180.)
Step 3. Remove the front cover. (See “Front and Top Covers” on page 181.)