Filter
Top Products
Chapter 6
Removing and Replacing Components
U320 SCSI Enablement and Conversion Procedures
235
Step 2. Pull the SCSI duplex board forward to disconnect the backplane connector and release it from the
disk drive cage.
Figure 6-34 Remove the SCSI Duplex Board
Removing the SCSI Backplane
You must replace the SCSI backplane for both simplex and duplex configurations. To remove the SCSI
backplane, follow these steps:
Step 1. Unplug the internal SCSI cables from the SCSI backplane.
Step 2. Unplug the SCSI backplane-to-midplane riser cable from the SCSI backplane.
Step 3. If the server is configured for simplex operation, remove the SCSI Jumper Cable (Figure 6-35).