Filter
Top Products
Chapter 6
Removing and Replacing Components
U320 SCSI Enablement and Conversion Procedures
241
NOTE If the server is pedestal mounted, you need not remove the pedestal to perform the
duplex to simplex conversion. Proceed directly to the next step.
Step 2. Remove the front bezel. (See “Removing the Front Bezel” on page 180.)
Step 3. Remove the front cover. (See “Removing the Front Cover” on page 181.)
Step 4. Remove the memory extender board. (See “Memory Extender Board” on page 184.)
Step 5. Remove the processor extender board. (See “Processor Extender Board” on page 192.)
Step 6. Remove the top cover from the chassis. (See “Removing the Top Cover” on page 182.)
Convert to Simplex
To convert to simplex, follow these steps:
Step 1. Unplug the SCSI B cable from the SCSI backplane.
Figure 6-39 Unplugging SCSI Cable B from the SCSI Backplane