Filter
Top Products
Chapter 6
Removing and Replacing Components
U320 SCSI Enablement and Conversion Procedures
237
Step 7. Push the SCSI backplane away from the disk drive cage and lift it up and out of the chassis.
Figure 6-36 Lift the SCSI Backplane Out of the Chassis
Replacing the SCSI Backplane
To replace the SCSI backplane, follow these steps:
Step 1. Replace the SCSI backplane to the rear of the disk drive cage (HP part number A6961-04075).
Step 2. If your system is configured for simplex operation, connect the SCSI jumper cable to the SCSI
backplane connectors.
Step 3. Replug the SCSI backplane-to-midplane cable back into the SCSI backplane.
Step 4. Replug the internal SCSI cable into the SCSI back plane.
If the server is configured for simplex operation, continue the upgrade at “Installing the Server Components”
on page 239
Backplane With Jumper
Cable Attached