Filter
Top Products
32 Océ TDS400 User Manual
Cut media
If the material does not have a straight leading strip, you can cut the material
at right angles from the roll.
▼ Cut the material from roll 1 or roll 2
1
Open the drawer.
2 Feed the paper manually until it is 5 cm above the top drawer.
3 Press the On-line key to put the printer off-line.
4 Close the paper drawer.
5 Select the ‘Media settings’ item with the or key.
6 Press Next/select to enter the ‘Media settings’ menu.
7 Select ‘Cut media’ with the or key.
8 Press Next/select to cut the paper.
9 Open the paper drawer.
10 Remove the scrap of material.
11 Feed the material until you can see the material and put the material into
position (see Figure 61 on page 155) and (see Figure 65 on page 157).
12 Close the drawer.
13 Press the On-line key to put the printer on-line again.