Filter
Top Products
54 Océ TDS400 User Manual
Note: The system is ready to use. You can turn ON and OFF the scanner
separate from the printer and without any particular order.
▼ Turn off the scanner
1
Set the on/off switch at the rear of the scanner, to position ‘0’ (see Figure 10).
Start the copy process
If you press the Start key, and you do not change any settings, the settings of
the previous copy job are used or the default settings of the machine are used:
■ numberofcopies1
■ use roll 1
■ zoom 100%
■ synchro cut
■ no leading or trailing strip
■ auto exposure on; exposure setting 0.
Default settings are used in the following situations:
■ after turn on
■ after you press ‘cancel’ twice
■ after a time-out of 1 minute (since the end of previous copy job has expired).
If the Start key is pressed the original will be scanned. The original returns to
the operator if you have enabled the rewind function (see page 60). You can
make settings for the next job.
When the original returns, remove the original. A new original can be fed and
you can program new settings.
Make copies
The copying process starts when you press the Start key. Before you press the
Start key, you can change the settings.
▼ Feed the original
1
Insert the original face down and right aligned, along the original guide line on
the scanner feed table so that you can see the line (see Figure 11).