Filter
Top Products
Intel NetStructure
®
MPCBL0001 High Performance Single Board Computer 47
Technical Product Specification
Hardware Management Overview
3.6.2.1 Updating MPCBL0001 Firmware
To update the MPCBL0001 firmware for the Intel NetStructure
®
MPCBL0001 SBC, execute the
following commands.
1. Copy the update utility (fwpiaupd) and the firmware image file into the same directory in the
RedHat Linux host. Note: If using ftp for file transfer, use binary mode to transfer files. The
firmware image file or the utility file may get corrupted if binary mode is not used.
2. /fwpiaupd -ip [IPAddress] -user root -pwd cmmrootpass -ni -b -u -slot [slot#] filename.hex.
Note: The dot before / character in the command is required.
• IPAddress is the IP address of the CMM.
• At default, user is root. Password is cmmrootpass.
• slot# is slot 1 to 14 in the MPCHC0001 chassis.
• filename.hex is the firmware file.
Note: This "fwpiaupd" utility can only be supported on the Red Hat* Linux* 8.0 Platform. The Intel
NetStructure
®
MPCMM0001 Chassis Management Module is needed for this remote update.
The utility and upgraded firmware are part of the IPMC Firmware release package. It can be
downloaded from the Intel web site at http://www.intel.com/design/network/products/cbp/atca/
index.htm.
3.7 OEM IPMI Commands
This section documents the OEM style IPMI commands implemented and supported on the
MPCBL0001.
3.7.1 Reset BIOS Flash Type
This command resets the processor and changes the BIOS bank select signal so that CPU boots off
redundant BIOS bank.
Table 13. Reset BIOS Flash Type
76543210
NetFn/LUN NetFn = 3Ah (OEM Request) RsLUN
Command Cmd = 01h
Byte 1 BIOS checksum success/failure indication
00h – Checksum success
01h – Checksum failure
Byte 1 Completion code