Filter
Top Products
OCPRF100 MP Server System Technical Product Specification
Revision 1.0
81
NOTES: Default values are marked with the "†" symbol.
NOTES: Default values are marked with the "†" symbol.
Mode Output only
Bidirectional†
EPP
ECP
Selects the mode of the LPT port.
Base I/O Address 378h†
278h
178h
3BCh
Selects the base I/O address for LPT port. 178h is only available
when the LPT port is in EPP mode. Otherwise, 3BCh is available.
Interrupt IRQ 5
IRQ 7†
Selects the IRQ for LPT port.
DMA channel DMA 1
DMA 3†
Selects the DMA channel for LPT port when configured for ECP
mode.
Floppy disk controller Disabled
Enabled†
Auto
Enables embedded floppy disk controller.
Table 6-11: Advanced Chip Set Control Submenu
Feature Option Description
Extended RAM Step 1 MB†
1KB
Every location
Selects the thoroughness of the extended memory. If “1 MB” is
selected, BIOS tests each 1 MB boundary. If “1KB” is selected, BIOS
tests each 1KB boundary. If “Every location” is selected, BIOS tests
every byte. BIOS defaults to the fastest test.
L2 Cache Disabled
Enabled†
Enables the second level cache. The second level cache should be
disabled only for diagnostic purposes.
Multiboot Support Disabled†
Enabled
Enables Boot Device Selection.
Override PHP Switches Disabled†
Enabled
If enabled, all PCI slots power-up. If disabled, only PCI slots with
plug-in cards power-up.
Table 6-10: I/O Device Configuration Submenu