Filter
Top Products
TX Operation
Facsimile Programming 4 - 23
TX Operation
Default TX
This function is used to set the default TX mode of the fax unit. Two options are
available:
Note: In Memory Transmission Mode, you can retrieve your original document
sooner than you can in ADF TX (Direct Transmission) Mode.
1
Press the PROGRAM Key and scroll through the
menus until you reach the TX Operation Menu.
Press YES to begin programming.
2
Press 1 or scroll down to the Default TX menu and
press YES.
3
Using the Left and Right arrows, select the option
you wish to have as the default and press YES to
enter this selection into memory.
Choices Available Description
Memory TX When set in this mode, documents are scanned into
memory for transmission and dialing starts after the first
pages is scanned (Quick TX).
ADF TX (Direct
Transmission)
When set in this mode, documents are scanned for
transmission after connection has been made to the
receiving unit. (When the available memory is insufficient,
please select ADF TX for a successful transmission)
If line is not available, the message “LINE IS BUSY” will be
displayed. The facsimile will retry based on the number of
redial attempts and intervals that were preset.
TX OPERATION?
YES / or 1-2
1 DEFAULT TX?
OK=YES
*MEM TX ADF TX
-SELECT&PUSH”YES”-