Filter
Top Products
Error and Status Messages
6 - 4 Troubleshooting
Note: If you cannot solve the problem by taking above actions, turn the main
power switch off and then back on again. If this does not clear the error message,
write down the error message, and contact your sales or service representative.
Remove Paper
Standard Tray
The standard output tray is full. Remove paper from the output
tray.
Remove the paper from output
tray before it becomes full. If
you leave paper in the output
tray, it can cause a paper
misfeed.
Remove Paper
1Bin Tray
The PT270 (1bin tray) is full. Remove the paper from the
PT270 (1bin tray).
Remove the paper from the
output tray before it becomes
full. If you leave paper in the
tray, it can cause a paper
misfeed.
Reset Duplex
Unit Correctly
The AD370 (duplex unit) is not
set correctly.
Set the AD370 (duplex unit)
correctly.
Resetting Job... Resetting Print job. Wait for while.
Reset Tray XX
Correctly
There is no paper tray, or Tray
XX is not set correctly.
This message appears only for
the default tray. See “Job
Control Parameters” on page 7-
7.
Set the tray correctly.
Setting Changed
Cannot Print
The paper feed unit setting has
been changed, and the proof
print failed.
Configure the paper feed unit
correctly, and try again.
Waiting... Printer is waiting for the next
data to print.
Wait for a while.
Warming Up... The printer is now preparing for
printing.
Wait until the printer is warmed
up.
Messages Description Comments