Filter
Top Products
Connecting to the Printer
Introduction 1 - 3
Connecting the Printer Using the Network Interface Board 185
Connect the printer to the network using the Network Interface Board 185.
Follow these steps to connect the printer.
1
Confirm that you have the correct cable.
2
Confirm that the machine is turned off.
3
Loop the network cable. The loop should be about 10cm (4”) from the end of the cable on
the end closest to the printer.
4
Attach the ferrite core to the loop.
5
Attach the network cable to the 10BASE-T/100BASE-TX port on the machine.
•
Confirm that the cable is connected to the 10BASE-T/100BASE-TX port.
•
Do not connect the cable into the fax port.
6
Connect the other end of the cable into the network.
TAHX010E