Filter
Top Products
Chapter 2. Server setup roadmap
The installation process varies depending on the configuration of the server when it
was delivered. In some cases, the server is fully configured and just needs to be
connected to power and the network and started. In other cases, the server needs
to have hardware features installed, requires hardware and firmware configuration,
and requires the operating system to be installed.
Table 1. Server setup roadmap
Task Where to find information
Unpack Chapter 3, “What is included with your server,” on page 7
Install hardware
features
Chapter 5, “Installing and replacing optional devices,” on page 29
Chapter 6, “Installing and replacing customer replaceable units,” on
page 73
Connect Ethernet cable
and power cords to
network and power
connectors
“Rear view” on page 18
Start the server to
verify operation
“Turning on the server” on page 26
Review UEFI settings
and customize as
needed
“Starting the Setup Utility” on page 110
Configure RAID
controllers and arrays
“RAID controllers” on page 115
Check for firmware
updates
“Using the EasyUpdate Firmware Updater tool” on page 123
Install operating system
and basic drivers
“Using the ThinkServer EasyStartup program” on page 117
Install any additional
drivers needed for
added features
Refer to the instructions that came with the hardware option.
Configure Ethernet
settings in operating
system
See the operating system help. This step is not required if the
operating system was installed using the ThinkServer EasyStartup
program.
Test Integrated
Management Module
(requires the IMM
Premium option)
“Using the Integrated Management Module” on page 123
Install remote
management
applications
“Installing ThinkServer EasyManage software” on page 126
Install applications Refer to the documentation that accompanies the applications that
you want to install.
© Lenovo 2009. Portions © IBM Corp. 2009. 5