5. Align the flash device with the connector on the system board and push it into
the connector until it is firmly seated.
6. Press down on the retaining latch to lock the flash device into the USB
connector.
7. Reconnect the power cord and any cables that you removed.
8. Install and lock the side cover (see “Installing the side cover” on page 33).
9. Reconnect the power cord and any cables that you removed.
10. Turn on the peripheral devices and the server.
Removing the virtual media key
To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 29.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the side cover (see “Removing the side cover” on page 32).
3. Grasp the virtual media key and gently slide it up and off of the mounting tab.
1 Mounting bracket (feet)
2 Mounting tab
3 Virtual media key connector
4 Virtual media key (front)
62 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide