Filter
Top Products
56 USB port <x> disabled
• Press until Continue appears, and then press to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
57 Configuration change, held jobs were not restored
Press until Continue appears, and then press to clear the message.
58 Too many disks installed
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the extra disks.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many flash options installed
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess flash memory.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many trays attached
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the additional trays.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
61 Remove defective hard disk
• Press until Continue appears, and then press to clear the message and continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
62 Disk full
• Press until Continue appears, and then press to clear the message and continue processing.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
119