Filter
Top Products
5 Press repeatedly until Power Saver appears, and then press .
6 Press repeatedly to decrease or repeatedly to increase the number of minutes before the printer enters
Power Saver mode, and then press
. Available settings range from 2–240 minutes.
Note: Power Saver settings can also be adjusted by issuing a Printer Job Language (PJL) command. For more
information, see the Technical Reference available on the Lexmark Web site at www.lexmark.com/publications.
Restoring the factory default settings
1 From the control panel, press .
2 Press until Settings appears, and then press .
3 Press until Setup appears, and then press .
4 Press until Factory Defaults appears, and then press .
5 Press until Restore Now appears, and then press .
Restoring Factory Defaults appears.
Warning: Restore Now returns all printer settings to the factory default settings except Network/Port menu
settings. All downloads stored in RAM are deleted. Downloads stored in flash memory or on a printer hard disk
are not affected.
Encrypting the printer hard disk
This functionality is available only when a printer hard disk is installed and working properly.
Warning: All files and resources on the printer hard disk will be deleted. Resources residing in the printer flash
memory or RAM will not be affected.
1 Turn the printer off.
2 From the control panel, press and hold and while turning the printer on.
3 Release both buttons when Performing Self Test appears.
The printer performs its power-on sequence, and then CONFIG MENU appears.
4 Press repeatedly until Disk Encryption appears, and then press .
5 Press repeatedly until appears next to Enable or Disable, and then press .
Note: Select Enable to enable hard disk encryption or Disable to disable hard disk encryption.
Contents will be lost. Continue? appears.
6 Press repeatedly until Yes appears, and then press .
A progress bar appears.
7 Press repeatedly until Exit Config Menu appears, and then press .
The printer performs its power-on sequence, and then Ready appears.
143