Filter
Top Products
Menu item Description
Standby Mode
Disabled
1–240
Sets the amount of time in minutes the printer waits—in a
ready-to-print state, after a job is printed—before passing into
Power Saver mode
Notes:
• Disabled is the factory default setting.
• This setting must be less than or equal to the Power Saver
mode setting.
Alarms
Alarm Control
Toner Alarm
Staple Alarm
Hole Punch Alarm
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
• Single is the factory default setting for Alarm Control.
Single sounds three quick beeps.
• Off is the factory default setting for Toner Alarm, Staple
Alarm, and Hole Punch Alarm. Off means no alarm will
sound.
• Continuous repeats three beeps every 10 seconds.
• Stapler Alarm and Hole Punch Alarm are available only
when the finisher is installed.
Timeouts
Screen Timeout
15–300
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255
Sets the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job
Notes:
• 90 seconds is the factory default setting.
• When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks to see if
any new print jobs are waiting.
• Print Timeout is available only when using PCL or PPDS
emulation. This setting has no effect on PostScript
emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535
Sets the amount of time in seconds the printer waits for
additional data before canceling a print job
Notes:
• 40 seconds is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL or
PPDS emulation print jobs.
82