Filter
Top Products
Chapter 3 Configuration and Installation
© National Instruments Corporation 3-9 GPIB-1014 User Manual
Table 3-4. GPIB-1014 Pin Assignment on VMEbus Connector P2
Signal Signal Signal Signal
Pin No. Used Not Used Notes Pin No. Used Not Used Notes
A1 CA15 1,4 A17 User I/O
A2 CA13 1,4 A18 User I/O
A3 CA11 1,4 A19 User I/O
A4 CA9 1,4 A20 User I/O
A5 User I/O A21 DIO5* 2,4
A6 User I/O A22 DIO6* 2,4
A7 User I/O A23 DIO7* 2,4
A8 User I/O A24 DIO8* 2,4
A9 User I/O A25 REN* 2,4
A10 User I/O A26 GND 2,4
A11 User I/O A27 GND 2,4
A12 User I/O A28 GND 2,4
A13 User I/O A29 GND 2,4
A14 User I/O A30 GND 2,4
A15 User I/O A31 GND 2,4
A16 User I/O A32 GND 2,4
B1 +5V B17 D19
B2 GND B18 D20
B3 3 B19 D21
B4 A24 B20 D22
B5 A25 B21 D23
B6 A26 B22 GND
B7 A27 B23 D24
B8 A28 B24 D25
B9 A29 B25 D26
B10 A30 B26 D27
B11 A31 B27 D28
B12 GND B28 D29
B13 +5V B29 D30
B14 D16 B30 D31
B15 D17 B31 GND
B16 D18 B32 +5V
C1 CA14 1,4 C17 User I/O
C2 CA12 1,4 C18 User I/O
C3 CA10 1,4 C19 User I/O
C4 User I/O C20 User I/O
C5 User I/O C21 DIO1* 2,4
C6 User I/O C22 DIO2* 2,4
C7 User I/O C23 DIO3* 2,4
C8 User I/O C24 DIO4* 2,4
C9 User I/O C25 EOI* 2,4
C10 User I/O C26 DAV* 2,4
C11 User I/O C27 NRFD* 2,4
C12 User I/O C28 NDAC* 2,4
C13 User I/O C29 IFC* 2,4
C14 User I/O C30 SRQ* 2,4
C15 User I/O C31 ATN* 2,4
C16 User I/O C32 User I/O
Notes
1. Compare Address lines. Can be used to set base address of GPIB-1014.
2. GPIB signals used for GPIB I/O via P2.
3. Reserved pin. Defined by the VMEbus specification.
4. For models GPIB-1014-1S and GPIB-1014-1S-EH. These signals are not connected to the P2 connector.