Filter
Top Products
Chapter 6: Operation 6-7
Operating Instructions
Power Up
The 7870 has no ON/OFF switch. The checkstand should be equipped
with a circuit breaker switch during site preparation. The switch
should be easily accessible and near the operator.
Power up the NCR 7870 on by turning the circuit breaker switch to
ON. The NCR 7870 performs diagnostic checks during the power up
procedure. If a scale error occurs, the yellow Status Indicator will light
and an error code will appear on the NCR 7825 Remote Display or
Integrated Display. If a scanner error is detected, and error tone will
sound and the red and green Status Indicator lights will flash a code.
In the event of a problem in the power up process, call a supervisor,
service company, or the NCR Customer Service Center for assistance.
Scanner Only Models
For the 1000 and 3000 models, if no error occur during power up the
unit will enter Startup Mode. The red Status Indicator will flash, the
green Status Indicator will flash, and a tone will sound. The red Status
Indicator will then light. The unit is ready for use.
Scanner/Scale Models
For the 2000, 4000, and 4500 models, if no errors occur during power
up the unit will enter Startup Mode. The red Status Indicator will flash
and all segments on the display (remote or integrated) will be turned
on for five seconds. The green Status Indicator light will flash , a tone
will sound, and the display will show SCALE READY 0.000 kg or
SCALE READY 0.00 lb. The red Status Indicator will light. The unit is
ready for use.
The Scanner/Scale models should warm up for five minutes before
being put into use.