Filter
Top Products
6-10 Chapter 6: Operation
Changing the Good Read Tone
The volume of the Good Read Tone can be changed while in normal
operating mode. This is the only characteristic of the tone that can be
changed without being in Programming Mode.
Instructions
1.
Scan the Volume Adjustment tag and listen to the tone.
2.
If the tone is not loud enough, scan the tag again. Repeat if
necessary.
3.
If the tone is too loud, scan the tag repeatedly until the volume
resets to the lowest level. Now scan to the desired level.
4.
When the volume is acceptable, scan the Save and Reset tag to end.
If the Save and Reset tag is not scanned, the unit will not operate.