Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
200
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
2. Complete the settings as explained in the following table:
3. Click Apply
to save your settings. The IPSec VPN policy is now added to the List of VPN
Policies table on the VPN Policies screen for IPv4. By default, the VPN policy is enabled.
Table 43. IPSec VPN Wizard settings for a client-to-gateway tunnel
Setting Description
About VPN Wizard
This VPN tunnel will connect
to th
e following peers
Select the VPN Client radio button. The default remote FQDN (remote.com)
and the default local FQDN (local.com) display in the End Point Information
section of the screen.
Connection Name and Remote IP Type
What is the new Connection
Na
me?
Enter a descriptive name for the connection. This name is used to help you to
manage the VPN settings; the name is not supplied to the VPN client.
What is the pre-shared key? Enter a pre-shared key. The key needs to be entered both here and on the
remote VPN gateway, or the remote VPN client. This key needs to have a
minimum length of 8 characters and cannot exceed 49 characters.
End Point Information
a
a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of
an IP address and an FQDN is not supported.
What is the Remote
Identifier Information?
When you select the Client radio button in the About VPN Wizard section of
the screen, the default remote FQDN (remote.com) is automatically entered.
Use the default remote FQDN, or enter another FQDN.
Note: The remote ID on the wireless VPN firewall is the local ID on the VPN
clien
t. It might be less confusing to configure an FQDN such as client.com as
the remote ID on the wireless VPN firewall and then enter client.com as the
local ID on the VPN client.
What is the Local Identifier
Information?
When you select the Client radio button in the About VPN Wizard section of
th
e screen, the default local FQDN (local.com) is automatically entered. Use
the default local FQDN, or enter another FQDN.
Note: The local ID on the wireless VPN firewall is the remote ID on the VPN
clien
t. It might be less confusing to configure an FQDN such as router.com
as the local ID on the wireless VPN firewall and then enter router.com as the
remote ID on the VPN client.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
These fields are masked out for VPN client connections.
What is the remote LAN
Sub
net Mask?