Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
218
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
IKE Policies Screen
To access the IKE Policies screen:
Select VPN > IPSec VPN. The I
PSec VPN submenu tabs display with the IKE Policies
screen in view. In the upper right of the screen, the IPv4 radio button is selected by default.
The IKE Policies screen displays the IPv4 settings. (The following figure shows some
examples.) To display the IPv6 settings on the IKE Policies screen, select the IPv6 radio
button.
Figure 137.
Each policy contains the data that are explained in the following table. These fields are
explained in more detail in Table 51 on p
age 221.
Table 50. IKE Policies screen information for IPv4 and IPv6
Item Description
Name The name that identifies the IKE policy. When you use the VPN Wizard to set up a VPN
p
olicy, an accompanying IKE policy is automatically created with the same name that you
select for the VPN policy.
Note: The name is not supplied to the remote VPN endpoint.
Mode The exchange mode: Main or Aggressive.
Local ID The IKE/ISAKMP identifier of the wireless VPN
firewall. The remote endpoint needs to
have this value as its remote ID.
Remote ID The IKE/ISAKMP identifier of the remote end
point, which needs to have this value as its
local ID.
Encr The encryption algorithm that is used for the IKE sec
urity association (SA). This setting
needs to match the setting on the remote endpoint.
Auth The authentication algorithm that is used for th
e IKE SA. This setting needs to match the
setting on the remote endpoint.
DH The Diffie-Hellman (DH) group that is used whe
n keys are exchanged. This setting needs
to match the setting on the remote endpoint.