Filter
Top Products
Monitor System Access and Performance
337
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 82. Broadband Traffic Meter screen settings
Setting Description
Enable Traffic Meter
Do you want to
enab
le Traffic
Metering on
Broadband?
Select one of the following radio buttons to configure traffic metering:
• Yes. Traffic metering is enabled, and the traffic meter records the volume of
Internet traffic passing through the WAN interface. Complete the fields that are
shown on the right side of the screen (see explanations later in this table).
• No. T
raffic metering is disabled. This is the default setting.
Select one of the following radio buttons to specify if or how the wireless VPN
firewall applies restrictions when the traffic limit is reached:
• No Limit. No restri
ctions are applied when the traffic limit is reached.
• Do
wnload only. Restrictions are applied to incoming traffic when the traffic limit is
reached. Fill in the Monthly Limit field.
• Both Dire
ctions. Restrictions are applied to both incoming and outgoing traffic
when the traffic limit is reached. Fill in the Monthly Limit field.
Monthly Limit Enter the monthly traffic volume limit in MB. The default setting is
0 MB.
Increase this
month limit by
Select this check box to temporarily increase a previously
specified
monthly traffic volume limit, and enter the additional
allowed volume in MB. The default setting is 0 MB.
Note: When you click Apply to save these settings, this field is
reset
to 0 MB so that the increase is applied only once.
This month limit This is a nonconfigurable field that displays the total monthly
traffic volume limit that is applicable to this month. This total is
the sum of the monthly traffic volume and the increased traffic
volume.
Traffic Counter
Restart Traffic
Coun
ter
Select one of the following radio buttons to specify when the traffic counter restarts:
• Rest
art Traffic Counter Now. Select this option, and click Apply at the bottom of
the screen to restart the traffic counter immediately.
• R
estart Traffic Counter at a Specific Time. Restart the traffic counter at a
specific time and day of the month. Fill in the time fields, and select AM or PM and
the day of the month from the drop-down lists.
Send e-mail report
before rest
arting
counter
An email report is sent immediately before the counter restarts. Ensure that emailing
of logs is enabled on the Email and Syslog screen (see Configure Logging, Alerts,
and Event Notifications on p
age 338).