Filter
Top Products
Using the BayStack 450 10/100/1000 Series Switch
2-10
302401-D Rev 00
Console/Comm Port
The serial console interface is an RS-232 port that enables a connection to a PC or
terminal for monitoring and configuring a standalone switch or a stack
configuration. You can also connect this port to an external modem to enable
remote dial-in management of the switch. The port is a male DB-9 connector,
implemented as a data communication equipment (DCE) connection.
To use the Console/Comm port, you need the following equipment:
• A terminal or TTY-compatible terminal, or a portable computer with a serial
port and the ability to emulate a terminal
The terminal should have the following settings:
- 9600 baud
- No parity
- 8 bits
- 1 stop bit
- Window Terminal Emulator option set to NO
- Terminal Preferences: Function, Arrow, and Control keys active
- Buffer size set to 24
• A UL-listed straight-through RS-232 cable with a female DB-9 connector for
the console port on the switch
The other end of the cable must have a connector appropriate to the serial port
on your computer or terminal. (Most terminals or computers use a male DB-25
connector.)
Any cable connected to the console port must be shielded to comply with
emissions regulations and requirements.
See “DB-9 (RS-232-D) Console/Comm Port Connector” on page E-1 for a
description of the pin assignments.
kombk.book Page 10 Tuesday, June 29, 1999 3:25 PM