Filter
Top Products
Using the BayStack 450 10/100/1000 Series Switch
3-14
302401-D Rev 00
Read-Write
Community String
The community string used for in-band read-write SNMP operations.
Default Value private
Range Any ASCII string of up to 32 printable characters
Trap #1 IP Address
1
Number one of four trap IP addresses. Successive trap IP address fields are
numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
Community String
The community string associated with one of the four trap IP addresses (see
Trap #1 IP Address).
Default Value Zero-length string
Range Any ASCII string of up to 32 printable characters
Authentication Trap
Determines whether a trap will be sent when there is an SNMP
authentication failure.
Default Value Enabled
Range Enabled, Disabled
Link Up/Down Trap
Determines whether
Link Up
or
Link Down
traps will be sent from the switch.
Default Value Enabled
Range Enabled, Disabled
1 The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel Networks proprietary MIB).
The status of the row in the MIB table can be set to Ignore. If the row status is set to Ignore, the fields appear to be set
when viewed from the console terminal; however, no traps will be sent to that address until the row status is set to Valid.
Table 3-3. SNMP Configuration Screen Fields
(continued)
Field Description
kombk.book Page 14 Tuesday, June 29, 1999 3:25 PM