Nortel Networks 450 Switch User Manual


 
Using the Console Interface
302401-D Rev 00
3-45
Port Mirroring Configuration
The Port Mirroring Configuration screen allows you to configure a specific switch
port to monitor up to two specified ports or two MAC addresses. You can specify
port-based monitoring or address-based monitoring. In a stack configuration, you
can monitor ports that reside on different units within the stack.
For more information about the port mirroring feature, see “Port Mirroring
(Conversation Steering)” on page 1-76.
Figure 3-20
shows an example of a Port Mirroring Configuration screen, in a stack
configuration, where port 12 (in stack unit 3) is designated as the monitoring port
for ports 5 and 6 of stack unit 4. When installed as a standalone switch, the screen
does not display the (Unit/) field designation.
Choose Port Mirroring Configuration (or press i) from the Switch Configuration
Menu screen to open the Port Mirroring Configuration screen.
Figure 3-20. Port Mirroring Configuration Screen
Port Mirroring Configuration
Monitoring Mode: [ -> Port X or Port Y -> ]
Monitor Unit/Port: [ 3/12 ]
Unit/Port X: [ 4/5 ]
Unit/Port Y: [ 4/6 ]
Address A: [ 00-00-00-00-00-00 ]
Address B: [ 00-00-00-00-00-00 ]
Port mirroring configuration has taken effect.
Currently Active Port Mirroring Configuration
---------------------------------------------
Monitoring Mode: -> Port X or Port Y -> Monitor Unit: 3 Port: 12
Unit X: 4 Port X: 5 Unit Y: 4 Port Y: 6
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
kombk.book Page 45 Tuesday, June 29, 1999 3:25 PM