Filter
Top Products
Using the BayStack 450 10/100/1000 Series Switch
2-22
302401-D Rev 00
4.
Select IP Configuration/Setup (or press i) from the Main Menu.
This selection displays the IP Configuration/Setup screen (Figure 2-17
).
Figure 2-17. IP Configuration/Setup Screen (Stack Configuration)
5.
Enter the Stack IP address in the In-Band Stack IP Address field, then
press [Return].
The In-Band Switch IP Address field (directly below the In-Band Stack IP
Address field) is not required for the operation of the stack. The In-Band
Switch IP Address field allows this switch to operate as a standalone switch.
You cannot configur both IP address fields to use the same IP address.
Note:
The IP interface of the BayStack 450 switch is only on VLAN 1.
You can manage the switch only from VLAN 1 (or via routers that connect
VLAN 1 to the network management station).
IP Configuration/Setup
BootP Request Mode: [ BootP Disabled ]
Configurable In Use Last BootP
------------------- --------------- ---------------
In-Band Stack IP Address: [ 0.0.0.0 ] 0.0.0.0
In-Band Switch IP Address: [ 0.0.0.0 ] 0.0.0.0
In-Band Subnet Mask: [ 0.0.0.0 ] 0.0.0.0 0.0.0.0
Default Gateway: [ 0.0.0.0 ] 0.0.0.0 0.0.0.0
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
kombk.book Page 22 Tuesday, June 29, 1999 3:25 PM