12
|
Handbook
Overview
Setting Up Your
OKIOFFICE MFP
To install your new OKIOFFICE MFP, follow the instructions
in this section. You must complete these steps for your
OKIOFFICE MFP to operate properly:
• Safety
• Unpacking
• Setting Up
• Setting the Date, Time, and ID
• Installing JetSuite Pro Software
Safety
Installation Hints
• Install your MFP in a dust-free location away from direct
sunlight
• Do not plug your MFP into a power source shared by
equipment that produces electrical noise (i.e., air
conditioners, etc)
• Leave electronic adjustments to authorized service
personnel
• The LINE terminal connects your MFP to a standard
telephone line. To avoid damage to your telephone system
or to the MFP, do not plug your MFP into anything other
than a standard RJ-11C jack.
• Your MFP is intended to be grounded electrically and is
equipped with a three-wire grounded power cord. For
your safety, do not attempt to defeat your power cord’s
grounding plug.
• The electrical outlet and phone jack should be installed
near the equipment and should be easily accessible.
• The two TEL terminals on the back of the MFP are only
suitable for 2 wire devices. Not all standard telephones
will respond to incoming calls when connected to an
extension jack.
• This equipment may not necessarily provide for the
effective hand-over of a call from a telephone connected to
the same line.
• The operation of this equipment on the same line as
telephone or other equipment with audible warning
devices, such as call waiting or automatic ring detectors,
may cause false tripping of the ring detector.