Filter
Top Products
161
ON. When the SV in 005 has expired, 00201 is turned OFF. This bit will also be
turned OFF when TIM 001 is reset, regardless of whether or not SV has expired.
00000
TIM 000
00001
TIM 001
00200
00201
015.0 s
TIM 000
#0150
TIM 001
IR 005
IR 005
Address Instruction Operands
00000 LD 00000
00001 TIM 000
# 0150
00002 LD TIM 000
00003 OUT 00200
00004 LD 00001
00005 TIM 001
005
00006 AND NOT TIM 001
00007 OUT 00200
There are two ways to achieve timers that operate for longer than 999.9 se-
conds. One method is to program consecutive timers, with the Completion Flag
of each timer used to activate the next timer. A simple example with two
900.0-second (15-minute) timers combined to functionally form a 30-minute tim-
er.
00000
TIM 001
TIM 002
00200
900.0 s
900.0 s
TIM 001
#9000
TIM 002
#9000
Address Instruction Operands
00000 LD 00000
00001 TIM 001
# 9000
00002 LD TIM 001
00003 TIM 002
# 9000
00004 LD TIM 002
00005 OUT 00200
In this example, 00200 will be turned ON 30 minutes after 00000 goes ON.
TIM can also be combined with CNT or CNT can be used to count SR area clock
pulse bits to produce longer timers. An example is provided in 5-14-4 COUNTER
– CNT.
TIM can be combined with KEEP(11) to delay turning a bit ON and OFF in refer-
ence to a desired execution condition. KEEP(11) is described in 5-9-4 KEEP –
KEEP(11).
To create delays, the Completion Flags for two TIM are used to determine the
execution conditions for setting and reset the bit designated for KEEP(11). The
bit whose manipulation is to be delayed is used in KEEP(11). Turning ON and
OFF the bit designated for KEEP(11) is thus delayed by the SV for the two TIM.
The two SV could naturally be the same if desired.
In the following example, 00500 would be turned ON 5.0 seconds after 00000
goes ON and then turned OFF 3.0 seconds after 00000 goes OFF. It is neces-
sary to use both 00500 and 00000 to determine the execution condition for TIM
Example 2:
Extended Timers
Example 3:
ON/OFF Delays
Timer and Counter Instructions Section 5-14