Filter
Top Products
NetWare Version 4.x and 5.x PSERVER Setup
163
NetWare Version 4.
x
and 5
.x
PSERVER Setup
NIC destinations are case sensitive and will not be recognized if
they are typed incorrectly. By default, they are all lower case. If you
are setting up a NetWare 4 or 5 environment, the destination must
be renamed to uppercase to match the PCONSOLE entry.
The NIC can be used in a NetWare 4 or 5 environment with either
of the following options:
• Set the NIC up as a PSERVER, replacing a dedicated printer.
• Set the NIC up as an RPRINTER, interacting with an existing
PSERVER (see page -166).
NOTE: Following a PSERVER setup, bindery emulation is
required.
To configure the NIC as a PSERVER in a NetWare 4 or 5
environment:
1. Log in to the Novell as supervisor.
2. Enter PCONSOLE.
3. Press F4.
4. Select Print Queues.
5. Click Insert to add a queue.
6. Type in a new queue name and press ENTER.
7. Press Escape.
8. Select Print Servers.
9. Click Insert to add the new print server.
10. Type the name of the NIC. The default is M_xxxxxx or
M302_xxxxx for the Wireless Adapter where, xxxxxx
represents the last six digits of the NIC address found on the
configuration printout or control panel settings under Ethernet
Parameters, MAC address (e.g., M_091C1A or M302_00008).
11. Select this new print server and press ENTER.
12. Select Printers.
13. Click Insert to add a printer to the list.