Filter
Top Products
Chapter 10 Configuring The AS/400 For Printing
234
Configuring The AS/400 For Printing
To configure an AS/400 for printing, you must:
• set up the printing capability, and
• verify the setup with a print job.
You will need the following information:
Remote Printer Queue name
Set to ‘d1prn’ through ‘d8prn’.
NOTE: The Remote Printer Queue name must be in lowercase
letters. Do not use “PASS.”
NOTE: When the IPDS feature is installed, the queue name
‘d4prn’ is not available.
IP Address
The IP address for the NIC.
Setting Up Printing For ASCII Files
The next step is to set up the remote printing capability. There are
two ways to do this: you can either specify the LPR parameters
manually each time you send a file to the printer, or use Remote
Writer and a remote output queue for automatic printing to the
printer.
To Use LPR Manually
1. Start TCP/IP, if it is not already running, by entering the
command
STRTCP
.
2. At the AS/400 command line, enter
LPR
.
3. Figure 28 displays in bold the parameters you need to specify.