Filter
Top Products
Bindery PSERVER Setup (Netware 3.x, Netware 4.x, And Netware 5.x)
187
19. Type the name for the print server in the Print Server name
field. By default, the name is “M_xxxxxx”
where “xxxxxx”
equals the last six digits of the print server’s Ethernet address
(e.g., “M_091C1A”).
NOTE: The name you use here must match the name stored on
the NIC. This name can be found by using the
list
pserver
command. See “List Commands” on page 335 for
more information.
20. Select Define additional properties and click Create.
21. Click Assignments in the dialog that opens and then click
Add....
22. Select the printer you created earlier.
23. Click OK to assign this printer to this print server.
24. Click OK to close the Printer Servers Details dialog and make
the changes permanent.
25. Physically repower the printer to make the new settings take
effect.
Bindery PSERVER Setup
(Netware 3.
x
, Netware 4.
x
, And Netware 5.
x
)
A Bindery PSERVER setup is possible under both Netware 3.
x
,
Netware 4.
x
and Netware 5.
x
. If you are using Netware 4.
x
or
Netware 5.x, Bindery emulation is required. Please consult your
Novell manual on how to set up Bindery emulation. A Bindery set
up using PCONSOLE in Netware 3.x is described in “NetWare
Version 3.x RPRINTER Setup” on page -160. The setup using
PCONSOLE in Netware 4.
x
or Netware 5.
x
is described in
“NetWare Version 4.x and 5.x RPRINTER Setup” on page -166.