Filter
Top Products
4–56 Configuration Menus
Buffer Print
When enabled, the BUFFER PRINT parameter prints the EBCDIC data and
control codes received from the host as hex values. Refer to Chapter 6
for
information on how to obtain a hex code printout.
Translation Table
TRANSLATION TABLE prints out a table of the coax interface’s current character
set. This operation is valid only when the coax interface is selected.
Column 132 Wrap
When enabled, this option causes the printer to line wrap at 132 characters
despite the current print density allowing more characters per line.
PA1
PA1 is only valid when the printer is in the NOT READY state and the coax
System Network Architecture Character Set (SCS) data stream is active. This
function displays the “PA1 ENABLED” message when the ENTER key is pressed
and sends a special operator request to the host when the printer is made
READY. Refer to the
Programmer’s Reference Manual
for more information
about SCS.
PA2
PA2 is only valid when the printer is in the NOT READY state and the coax SCS
data stream is active. This function displays the “PA2 ENABLED” message when
the ENTER key is pressed and sends a special operator request to the host
when the printer is made READY.
Buffer Reprint
This option is valid only when the printer is printing in SCS mode. When the
ENTER key is pressed, “Buffer Reprint Enabled” is displayed and an Intervention
Required status is sent to the host. Pressing ENTER again cancels the Buffer
Reprint function and “Buffer Reprint Disabled” is displayed.