Filter
Top Products
4–62 Configuration Menus
Forms Length
Forms length is the number of lines that can be printed on a page. You can set forms
length in inches, millimeters (mm), or as a function of the current LPI (lines per inch).
Forms Width
The forms width can be specified in inches, millimeters, or as a function of the
current CPI (characters per inch). The forms width set should not exceed the
actual paper width.
Print Char Set
When this selection is displayed and the ENTER key is pressed, the current
character set is printed.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command (ESC @ or ESC[K) in
addition to resetting printer variables, the power up configuration will be loaded.
• Disable: The factory configuration is loaded when the reset command is
executed.
• Enable: The power up configuration is loaded when the reset command
is executed.
Downloaded fonts
This option allows you to download a substitution table to replace any character
in the current character set with a different character in the same font.
• Char Operations: This option allows you to delete a character from
flash, load a character from flash, and save a character to flash.
• Ld Char at Pwrup: This option allows you to disable or enable loading a
character set at power up.
• Set Operations: This option allows you to delete a character set from
flash, load a character set from flash, save a character set to flash, and
delete a character set from RAM.
• Ld Set at Pwrup: This option allows you to disable or enable loading a
character set at power up.