Filter
Top Products
4–86 Configuration Menus
Character Sets
This parameter selects a character set for the ANSI emulation. Note that when
0876 OCR–A or 0877 OCR–B is selected as the print language, the print quality
is changed to OCR–A or OCR–B, respectively. Character sets are shown in detail
in the
Character Sets Reference Manual
.
Printer Select
This option determines if the ASCII DC1 and DC3 control codes can be used to
disable and enable the printer.
• ON = DC1/OFF = DC3 disables the printer when a DC1 control code is
received, and enables the printer when a DC3 control code is received.
• DISABLE ignores the DC1 and DC3 control codes.
ESC c Sequence
This option resets the printer parameters to the factory defaults.
Received CR
This option determines if a received CR is handled as a Carriage Return or if it is ignored.
Received Del
Similar to the CR option, this determines if a received DEL should be handled as
a Delete or ignored.
Private Mode
This menu option determines the default type of character set (Set 1 or Set 2).
This can also be set by ESC sequences ESC [>5h and ESC [>51. Refer to these
descriptions for further detail.
Pos. on BC/OvrSz
This option determines where the logical printhead is located after printing bar
codes or oversized characters. If the options are set to “Set to top,” the paper is
fed back to the top of the bar codes or oversized characters. This allows printing
on the same line. If set to “Set to bottom,” the printer will continue printing without
backing up.