Filter
Top Products
Commands4–62
BOLD # Selects a bold attribute. Enter BOLD, a space, and ON
or 1 to turn bold on, or OFF or 0 for no bold attribute.
SLANT # Selects a slanting factor. (Slant is similar to italic, but
also offers a backward slant.) Enter SLANT, a space,
and RIGHT or 1 for a typical italic slant, LEFT or –1
for a backward slant, or OFF or 0 for no slant attribute.
SYMSET # Selects a font symbol set other than the default ASCII
symbol set. Enter SYMSET, a space, and a value
ranging from 0 to 31 representing the symbol set as
identified in Table 7–1 on page 7–2 in the
“Multinational Character Sets” chapter.
POINT # Selects the point size for the current typeface. Enter
POINT, a space, and a point size ranging from 4 to
999. Point sizes are available in quarter–point
increments. Horizontal pitch is automatically adjusted
based on the point size selected.
The point parameter cannot be used when in CREATE
mode. Use the point parameter of the alpha command.
NOTE: The fonts available are the standard font (#93779) and (#93952); OCR–A
(#90993); and OCR–B (#91409). Other type face numbers will correspond
to the CG Triumvirate font. CG Triumvirate is the proportional font and is
available in the following point sizes.
5
6 8 10 12 14 18 24 30 36
Comments Font parameters in Normal and Execute modes do not affect the fonts that
have already been established and saved on a form.
Font commands issued in the Create mode affect only the current form
being created and not any of the fonts on other forms or for Execute or
Normal mode text.
You can use any or all Font parameters, listed in any order, in a single Font
command. (Do not list font parameters on separate lines.) Parameters and
symbol sets not specified retain the previously selected value. Parameters
incorrectly specified retain the previously selected value.