Filter
Top Products
Commands4–36
Corners
Purpose Defines corner sets.
Mode CREATE
Format CORNER
LT; SR; SC; ER; EC; VL; HL
STOP
CORNER Enter CORNER to expand corners down and to the
right from the given row and column.
LT Defines the line thickness, measured in dots. Line
thickness is based on dot dimensions of 1/72”
vertically. Enter a value of 1 or greater.
SR Defines the starting row of the corner. Enter a value
ranging from row 1 through one less than the length of
the form. Character row or dot row is specified based
on the Scale command (page 4–88), or use the CP.DP
format (page 4–7).
SC Defines the starting column of the corner. Enter a value
ranging from column 1 through one less than the width
of the form. Character column or dot column is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
ER Defines the ending row of the corner. Enter a value
ranging from row 2 through the last row of the form.
The ending row must be greater than the starting row.
Character row or dot row is specified based on the
Scale command (page 4–88), or use the CP.DP format
(page 4–7).