Filter
Top Products
1–14 Introduction
Option
Parameter
Value
Comments
Ext Execute Copy DISABLE*
ENABLE
If DISABLED, dynamic data, overlay data, etc. are not
allowed
if
the optional Form Count parameter is specified
as part of the Execute command.
If
ENABLED,
dynamic data, overlay data, etc. are allowed
within a form in which the Form Count parameter is
specified in the Execute command. In this case, the exact
same
form (with identical dynamic
data, etc.) is printed for
whatever
the Form Count is. Also, each form is printed on
a
separate page.
Host Form Length DISABLE
ENABLE*
DISABLE sets the form length to the value set from the
front
panel. ENABLE sets the printer page size equal to the
form length defined in the CREATE FORM mode.
Power On IGP/PGL DISABLE
ENABLE*
DISABLE puts printer in QUIET mode at power–up,
otherwise ENABLE or LISTEN mode is active at
power–up.
Select SFCC 1 – 255 decimal
126 *
Select any ASCII character from Table 1–5 on page 1–16
to set the binary pattern for the selected Special Function
Control Character. Default is decimal 126 (~).
Uppercase DISABLE*
ENABLE
If
ENABLED,
all incoming data is converted to uppercase.