Filter
Top Products
6–19Form Examples and Exercises
Form Exercise
In the following example, you will create and execute a form. Using
character scaling (discussed in detail on page 4–88) on a 60 x 72 dot per inch
(dpi) grid, your form will include the following:
• a box
• a set of corners
• vertical lines
• alphanumeric data
• horizontal lines
• a bar code
This exercise will help you become familiar with the IGP/PGL by taking you
through 14 steps to build a complete form. Detailed command descriptions
for producing forms, bar codes, and logos are described in the “Commands”
chapter.
All the data and commands for the form are entered into a file in the host
computer. The filename used in this exercise is PRACTC.FRM, and the form
name used is PRACTICE. If another form named PRACTICE already exists,
it will be deleted by this exercise.
Begin each step by reading the explanation. The information you input is
listed under the word Enter. The parameters of each command have a
specific order for data entry; input the data exactly as shown, but always use
the actual SFCC required by your system where the ~ is shown. The general
command format is listed under the word Format next to each example. The
SFCC is represented by (cc) in the general format.
Use the standard commands on your system to open, close, or print the file
with the form data where your system format is required.
NOTE: Do not forget to terminate each command line with a line feed (or
carriage return with line feed), or a paper motion command. Enter
all commands in uppercase. Make sure the printer power is on and
the printer is READY, ON–LINE.