Filter
Top Products
1–8 Introduction
Table 1–1. Normal Mode Commands
Command Mnemonic Description Page #
Compressed Print DENSITY Defines the horizontal print density in characters per inch (cpi). 4–33
Configuration CONFIG Reconfigures IGP/PGL parameters. 4–34
Create CREATE Places
the IGP/PGL in the
Create Form mode where all the Create Form mode
commands are available to design form elements.
4–39
Create Logo LOGO Places
the IGP/PGL in the Create Logo mode, where logos can be defined using
the appropriate dot placements.
4–74
Delete Form DELETE FORM Deletes a selected form name from the directory and IGP/PGL memory. 4–41
Delete Logo DELETE LOGO Deletes a selected logo name from the directory and IGP/PGL memory. 4–42
Directory DIRECTORY Provides a list of all defined forms and logos, logo assignments to forms, and
memory usage and availability.
4–43
Execute EXECUTE Executes a previously created form. 4–49
Expanded Print EXPAND Expands fonts vertically and horizontally. 4–60
Font FONT Selects a specific typeface, bold, slant (italic) factor, and symbol set. 4–61
Ignore Sequence
On/Off
IGON
IGOFF
Enables the IGP/PGL to ignore all characters after the Ignore Sequence On
command
is sent until the Ignore Sequence Of
f command is sent. See Note on
Page 1–11.
4–65
Line Spacing,
Vertical
LPI Defines the lines per inch (lpi) printing format. 4–66
Listen LISTEN Removes IGP/PGL from the quiet state and enables IGP/PGL operation. 4–71
Multinational
Character Set
USET
ISET
Use
a multinational character set or create a custom user–defined character set.
Chapt. 6
Normal Mode NORMAL Places the IGP/PGL in the Normal mode, where it does not change the data
stream but awaits the SFCC followed by an IGP/PGL command.
4–77
Paper PAPER Selects features such as paper cutter, print intensity, label sensor, page
orientation (portrait/landscape), and print speed.
4–79
Print File PRINT Prints a file from external memory 4–83
Quiet QUIET IGP/PGL operation is disabled until a Listen command is received. Any data
sent to the LinePrinter Plus Emulation is unaffected by IGP/PGL commands.
4–84
Reset RESET Deletes all forms and logos from the IGP/PGL memory. 4–85
Select Format
On/Off
SFON
SFOFF
Ignores all host–generated paper movement commands. See Note on Page
1–11.
4–90
Set Up SETUP Automatically executes and loads the IGP/PGL commands into the printer at
power–up or after a RESET command is sent.
3–2
Printer Mode PMODE Included only for compatibility; not recommended for use. N/A
Scaling Mode SMODE Included only for compatibility; not recommended for use. N/A