Filter
Top Products
Error Codes8–12
Create Errors
60 Directory full – cannot CREATE the form or LOGO
The directory is full, or no more room exists in the IGP/PGL memory for
another form. When this occurs, the IGP/PGL automatically reverts to the
Normal mode. To create space in the IGP/PGL memory, delete forms that are
no longer required.
61 CREATE function unrecognized
An unrecognizable command is entered during the Create Form mode. At
this point, the buffer is flushed until a Stop command is found, and then
processing continues.
62 CREATE horizontal duplication parameter HDUP error
Either a format error was detected or a parameter was exceeded. The
duplication number must be no greater than 255, and the offset must be no
greater than 792 (dot scale). If this error occurs, the Horizontal Duplication
command is ignored, and forms processing continues.
63 CREATE vertical duplication parameter VDUP error
Either a format error was detected, or a parameter was exceeded. The
duplication number must be no greater than 255 and the offset must be no
greater than the specified length of the form. If this error occurs, the Vertical
Duplication command is ignored, and forms processing continues.
64 CREATE scale factor parameter SCALE invalid
Either a format error was detected, or a parameter was specified incorrectly.
The vertical lines per inch can be specified as 1 to the target DPI. The
horizontal characters per inch can be specified only as 10, 12, 13, 15, 17 or
20 cpi. If this error occurs, the Scale command is ignored and forms
processing continues.
65 CREATE page starting row PAGE SR out of bounds
When you specify the position of the page parameters with the Page
command in the Create Form mode, the row position specified will place the
page number above or below the boundaries of the form. When this error
occurs, the IGP/PGL will automatically revert to the Normal mode.