Filter
Top Products
Bar Codes5–102
e. Replace L with a number equaling the total
number of characters in the field. (The actual
data provided dynamically during the Execute
Form Mode can be less than L.)
f. The information for the data field is entered
dynamically during the Execute Form Mode.
(Refer to “Execute Form: Dynamic Bar Code
Data” on page 4–55 in the “Commands”
chapter.) Do not use the data field parameter to
enter data when the BFn parameters are used.
However, refer to the data field description for
available characters.
DARK Optional parameter to produce darker looking bar
codes. Enter DARK. Refer to “Dark Printing” on page
4–10 for more information.
SR Defines the starting row for the bar code. Enter a value
within the range of the 4–inch vertical address block.
Character row or dot row is specified based on the
Scale command (page 4–88), or use the CP.DP format
(page 4–7).
SC Defines the starting column of the bar code. Enter a
value between the 1/2–inch left and right margins of
the mailpiece. Character column or dot column is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
D The printable character (delimiter) identifying the start
and finish of the data field. Enter any printable
character other than a slash (/) the SFCC, or a character
used within the data. The same character must be used
at both ends of the data field but it will not print with
the data.
data field The bar code data. Enter 5 digits (for zip code), 9 digits
for a nine–digit zip code, or 11 digits (for the
Advanced Bar Code format). The available characters
for the data field are 0 through 9 (30 through 39 hex,
respectively).