Filter
Top Products
4–53Commands
Overlay Data Overlay data can be entered during the Execute Form
mode. (The words “Overlay Data” are not part of the
Execute command. They are shown in the command
sequence to indicate that actual overlay data can be
entered following the Execute command.) Refer to
“Execute Form: Overlay Data” on page 4–59.
Form Feed Character
Optional command instructing the IGP/PGL to start a
new page with new EVFU, dynamic, and overlay data
using the existing Execute commands for the current
form. Using this EVFU Data—Dynamic Data and
Overlay Data—Form Feed Character sequence can be
repeated indefinitely, while maintaining the optimum
print speed, within the original Execute command.
(cc)NORMAL The Normal mode command. If the form count
parameter was not used in the Execute command, enter
the SFCC and NORMAL to return the IGP/PGL to the
Normal mode.
The Normal mode command is input following all
other Execute commands to enter variable data. (Refer
to the following sections.) Input a line terminator to
leave a blank line before entering the Normal
command.